Earth Curve Calculator
The ground beneath a long view is not as flat as it looks. Over distance, the surface of the Earth falls away from any straight sight line. This calculator measures that fall in three useful ways. Enter a distance and your eye height above the surface. You then see the curvature drop at the target. The results also show how much of the target hides beyond your horizon. A midpoint bulge figure completes the picture.
Sailors, surveyors, photographers, and curious walkers all use these numbers. They explain why ships vanish hull first over the sea. They help photographers judge whether a distant peak should be visible. Radio planners even use a cousin of the same geometry. The sections below explain each idea in plain language. Two worked examples then run the numbers for a ten mile view. A short section on air refraction shows why real views sometimes beat the geometry. No instruments are needed beyond a map and your own height.
What Is the Curvature Drop?
Imagine a perfectly straight line leaving your eye, level with the horizon. The ground follows the curve of the planet instead. At any distance, the surface sits below that straight line. The vertical gap between line and surface is the curvature drop. It grows with the square of the distance, not evenly. Doubling the distance therefore multiplies the drop by four. That squaring is why short views look flat while long views hide whole buildings.
A famous rule of thumb captures the same idea. The surface drops about eight inches for every mile, squared. At one mile the drop is roughly eight inches. At ten miles it reaches about eight hundred inches, near sixty-seven feet. The rule ignores your eye height and the bending of light. It still lands close for quick estimates. The calculator replaces the rule with exact geometry for the same job.
Ancient observers noticed the effect long before formulas existed. Ships vanishing bottom first puzzled and then persuaded early thinkers. Mountain shadows and lunar eclipses added more clues over the centuries. Today the same geometry sits inside every chart plotter and survey instrument. What changed is only the effort required. A calculation that once filled a page now takes seconds here.
The Horizon and Hidden Height
Your eye height decides where your personal horizon sits. From ground level, that horizon is effectively at your feet. From six feet up, it lies about three miles away over water. Beyond the horizon, the surface keeps falling away from your sight line. The part of a target below that sight line is its hidden height. A tall target can still peek above the line while its base stays hidden. That is why distant ships lose their hulls before their masts.
Hidden height depends on both distance and eye height. Raising your eyes pushes the horizon farther out. The hidden portion of every target then shrinks. Climbing a modest hill can reveal surprising amounts of a distant shore. Lowering your eyes does the opposite within seconds. The calculator handles this by asking for eye height separately. Leave it at zero to model a sight line starting at the surface itself.
Lighthouses turn this relationship into a published service. Charts list each light’s height above the sea with care. Mariners combine that height with their own eye height. The sum predicts the range at which the light should appear. Generations of navigators have trusted that simple pairing. Your beach calculation uses exactly the same logic.
How to Use the Earth Curve Calculator
Five quick entries set up the whole calculation. Work through the form in order.
- Type the distance to your target.
- Choose miles or kilometres for that distance.
- Add your eye height above the surface.
- Pick feet or metres for the eye height.
- Select standard refraction or none, then press Calculate.
- Press Reset to clear the form for another view.
Results appear in metres and feet together for the drop and hidden height. The horizon distance arrives in kilometres. Try raising the eye height and watch the hidden figure fall.
Worked Example 1: Ten Miles From Ground Level
The Inputs
Take a target exactly ten miles away across flat water. Set the eye height to zero feet for the pure geometry case. Choose no refraction, so the planet uses its plain radius. That radius is six thousand three hundred seventy-one kilometres. The distance converts to about sixteen point zero nine kilometres. These settings isolate the curve itself from every other effect.
The Calculation
The drop formula squares the distance and divides by twice the radius. Sixteen point zero nine squared gives about two hundred fifty-nine. Dividing by twelve thousand seven hundred forty-two gives zero point zero two zero kilometres. That equals twenty point three metres of drop. With eye height at zero, the horizon distance is zero too. The hidden height therefore matches the full drop beyond the starting point. Midpoint bulge is the drop divided by four, about five point one metres.
The Result
The panel reports a drop of twenty point three metres, or sixty-six point seven feet. Hidden height reads the same twenty point three metres here. That matches the old eight inch rule almost exactly. Ten miles squared times eight inches gives eight hundred inches. Eight hundred inches is sixty-six point seven feet. Two very different methods agree on the answer.
Worked Example 2: Ten Miles From Six Feet Up
Now raise the observer to a standing eye height of six feet. The target stays ten miles away, with no refraction. The drop at the target does not change at all. It remains twenty point three metres, because drop ignores eye height. Everything else in the result panel shifts, though. Your horizon moves out to about four point eight three kilometres.
Hidden height uses the distance beyond that horizon. The target sits about eleven point two six kilometres past it. Squaring that remainder and dividing by twice the radius gives the hidden part. The result is about ten point zero metres, or thirty-two point seven feet. So a ten metre wall at ten miles would just peek into view. Its lower ten metres stay below your sight line.
Compare the two examples to see the eye height effect clearly. Six feet of height revealed about ten metres of extra target. The drop figure never moved, yet the visible portion doubled. Photographers exploit this by climbing dunes or towers at the shore. Even a small ladder changes what a long lens can capture. Eye height is the cheapest visibility upgrade there is.
The Midpoint Bulge, Explained
The bulge describes the hump of surface between you and the target. Picture a straight line stretched from your position to the target. Halfway along, the surface rises closest to that line. The gap there is the midpoint bulge. Its formula divides the squared distance by eight times the radius. That makes the bulge exactly one quarter of the total drop. Long bridges and canals must respect this gentle hump.
Surveyors meet the bulge whenever they level over distance. A level line of sight is straight, while the surface curves away beneath it. Readings taken far from the instrument need a curvature correction. The bulge figure estimates the largest such correction on a route. It also explains why a long lake can hide a low mid-way buoy. The hump blocks it even when both shores are visible.
Long canals were engineered with this hump in mind centuries ago. Water itself follows the curve, so locks and levels must agree with it. A perfectly straight canal bed would slowly climb out of the water. Builders learned to let the bed follow the planet instead. The bulge figure shows how large that adjustment grows with distance.
Refraction: Why the Air Bends the Answer
Light does not travel perfectly straight through the air. Air density changes with height, bending rays gently downward. That bending lets you see slightly farther than pure geometry allows. Surveyors model it by pretending the planet is a little larger. The standard trick multiplies the radius by seven sixths. The calculator offers that standard refraction as an option. Choosing none returns the pure geometric answer instead.
A quick test shows the size of the effect. Take a target thirty kilometres away and an eye height of two metres. With standard refraction, your horizon sits about five point four five kilometres out. The hidden height comes to roughly forty point five metres. The drop reads about sixty point five metres, with a bulge near fifteen point one metres. Without refraction, every one of those hidden figures would grow. Real air varies daily, so treat the standard as an average, not a promise.
Where These Numbers Matter
Shipping relies on horizon math for lights and lookout ranges. A lighthouse’s visible range starts with its height above the sea. Photographers use hidden height to plan skyline and mountain shots. Knowing a peak should clear the horizon saves wasted trips. Engineers check long sight lines for pipelines, canals, and laser links. Even radar and radio planning borrow the same curved geometry. Their signals bend slightly more, yet the starting model is identical.
Everyday curiosity uses the calculator just as well. Holiday photos across a bay raise the same questions. A ferry route, a wind farm, or a distant city skyline all qualify. Enter the map distance and your rough eye height. The results tell you how much should be visible on a clear day. Disagreement with reality usually points to refraction or haze. Both are worth a second look with the other refraction setting.
Offshore wind farms bring the topic into planning hearings. Residents ask how much of a distant turbine row will show. Developers answer with hidden height calculations like these. Tower height, blade height, and viewer height all enter the estimate. The same three numbers drive this calculator. Planning disputes often shrink once both sides share one set of figures.
Tips for Sensible Earth Curve Estimates
- Measure distance along the map, not along a winding road or path.
- Estimate eye height honestly, including any hill, dune, or tower you stand on.
- Run both refraction settings to see the realistic range of answers.
- Remember that drop ignores eye height, while hidden height depends on it.
- Use the eight inch rule only for rough checks at short distances.
- Allow extra margin for haze, waves, and tides on real water views.
Small care with the inputs keeps the geometry honest.
Frequently Asked Questions
General Questions
1. How much does the Earth curve over ten miles?
The surface drops about twenty point three metres below a level sight line. That equals roughly sixty-six point seven feet. The old rule of eight inches per mile squared gives the same answer. Eye height changes what you see, not this drop.
2. Why do ships disappear hull first?
The hull sits lowest, so the horizon hides it first. Masts and funnels rise higher and stay visible longer. Watching a ship sink from the bottom up is the hidden height effect in action. Binoculars cannot recover the part below the sight line.
3. What is the midpoint bulge?
It is the height of the surface hump halfway to your target. A straight line between two points passes above that hump. The bulge equals one quarter of the total curvature drop. Surveyors and bridge engineers correct for it on long spans.
4. Can I see the curvature from an aeroplane?
At cruising altitude the horizon sits hundreds of kilometres away. Its gentle dip below eye level is measurable with a straight edge. Casual window views rarely make it obvious to the eye. The calculator’s drop figures explain why the effect stays subtle.
5. Does the calculator prove the Earth is round?
It applies the standard spherical model used by surveyors. The formulas predict hidden heights that match everyday observations at sea. Test them against any distant shoreline target. The page offers the geometry, and your own eyes supply the check.
How the Calculation Works
6. What formula gives the curvature drop?
Square the distance, then divide by twice the planet’s radius. That simple form suits distances far smaller than the radius itself. It produces the drop below a level tangent line. The calculator converts the result into metres and feet.
7. How is the horizon distance found?
It comes from the square root of twice the radius times the eye height. Six feet of eye height gives about four point eight kilometres without refraction. Higher viewpoints stretch the horizon quickly at first. Gains slow as height keeps growing.
8. Why does hidden height use the distance past the horizon?
Nothing hides before your horizon, because the sight line still touches the surface there. Only the stretch beyond it falls below the line. Squaring that leftover distance gives the hidden amount. Eye height therefore enters the result through the horizon.
9. What does standard refraction change?
It inflates the working radius by a factor of seven sixths. That models light bending gently downward through the air. Drops and hidden heights shrink by roughly one seventh. Surveyors use this convention for everyday atmospheric conditions.
10. Why does the drop not depend on eye height?
Drop measures the surface against a level line from the target’s own tangent. That geometry involves distance and radius only. Eye height changes your personal sight line instead. It therefore affects hidden height and horizon, never the drop itself.
Practical Questions
11. How high must a target be to see it at twenty miles?
Run the calculator at twenty miles with your eye height entered. The hidden height result states exactly how much stays below view. A target taller than that figure will show its top. Compare the answer under both refraction settings for a range.
12. Do surveyors really correct for curvature?
Yes, levelling over long sights requires curvature corrections. The effect reaches millimetres within a few hundred metres. Precise work also subtracts a refraction allowance. Modern instruments often apply both corrections automatically.
13. Why can I sometimes see farther than the calculator says?
Unusual air layers can bend light more than the standard model. Cold water under warm air creates such conditions at sea. Distant objects then loom higher than geometry predicts. The no-refraction and standard settings bracket most ordinary days.
14. Does the target’s own height matter?
Yes, compare the target height with the hidden height result. Any part above the hidden figure should be visible. A one hundred metre tower at ten miles shows most of its length. A ten metre wall at that range barely peeks above the line.
15. What eye height should I enter at the beach?
Use the height of your eyes above the water surface. Standing at the water’s edge, that is roughly your height minus a little. Sitting on the sand lowers it to about a metre. Standing on a pier or dune raises it by that structure’s height.
CONCLUSION
Distance quietly hides the world, and now you can measure the hiding. Drop, hidden height, horizon, and bulge each answer a different question. Eye height and refraction tune the geometry to real conditions. Enter your next long view above and see what should be visible. The shoreline will never look quite the same again.
